5019 612 10057
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in
the table in relation to the water supply pressure and temperature, the load and the type of wash.
The data on the “Energy Label” refer to the programme “Cotton 60°C”.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the
water out.
1. Load the machine, close the drum doors and
check that they are properly locked.
2. Add detergents and additives into the dispenser
to no more then the “MAX” level mark, as
follows:
•
Programme with pre and main wash
•
Main wash programme without prewash
•
Fabric softeners and conditioners
•
Chlorine bleach
•
Stain remover agents
•
Anti-scale agents (if necessary)
3. Turn the programme selector knob to the
desired programme.
4. Turn the temperature selector knob to the
desired temperature.
5. Turn the spin speed selector knob to the
desired spin speed. If the spin speed “
” is
selected, the final spin is cancelled, but not the
intermediate spins. The programme ends with a
drain cycle.
Selecting or deselecting an option can be done
at any time during the programme. The option
will be applied as long as the corresponding
programme phase has not been executed yet.
“Rapid” button
• For fast, energy saving wash cycles.
• Ideally suited for small loads consisting of lightly
soiled laundry.
“Half Load” button
• Can be used for small loads and lightly soiled
laundry.
• Reduces the water consumption especially during
the rinses.
“Intensive Rinse” button
• The amount of water is increased to ensure a
more intensive rinse.
• This option is particularly suitable for areas with
very soft water or washing linen laundry for
people with skin allergies.
CONSUMPTION DATA
Programme
Temperature
Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes)
Cotton
95
5.0
63*
1.80
2:05
Cotton
60
5.0
55
1.20
2:05
Cotton
40
5.0
55
0.55
2:05
Synthetic
60
2.0
56
0.80
1:30
Synthetic
40
2.0
56
0.40
1:30
Delicate
40
1.5
60
0.55
0:45
Wool
40
1.0
60
0.50
0:40
Silk
30
1.0
60
0.30
0:50
PREPARATION OF WASH CYCLE
SELECT THE DESIRED OPTION
“Rinse Hold” button
• The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from fading.
• This option is particularly recommended for the
“Synthetic”, “Delicate” and “Daily Mixed”
programmes.
• This function is particularly useful if you want to
postpone spinning to a later time, or if you want
to drain only.
Note: the programme selector knob stops
on
.
Appliance in “Rinse Hold”:
• Press the “Rinse Hold” button again: the
programme will terminate automatically with
the selected spin cycle.
• If you do not wish to spin the clothes, press the
“On/Off” button, turn the programme selector
knob to the “Drain” programme and press the
“On/Off” button again.
Turn on the tap and press the “On/Off” button.
The indicator light of the “On/Off” button lights up.
Note: If there is a power interruption or if the
appliance is disconnected during the cycle, the
programme will run again from the point where it
was interrupted.
• The programme selector knob is in the Stop
position.
1. Press the “On/Off” button to switch off the
machine.
2. Cancel the options.
3. Turn the tap off.
4. Wait for the lid to unlock (about 1 minute).
5.
Open the lid and the drum doors and unload
the machine.
1. Switch off the machine by pressing the
“On/Off” button.
2. Select the new programme.
3.
Start programme by pressing the “On/Off”
button again.
If, for any reason, you wish to interrupt the
programme for a certain time and continue it later:
1. Press the “On/Off” button.
2. After the desired pause, press again the
“On/Off” button.
1. Switch off the machine by pressing the
“On/Off” button.
2. Set the programme selector to “Drain”.
3. Press the “On/Off” button again to start the
“Drain” programme.
PROGRAMME START
END OF WASH CYCLE
CHANGE THE PROGRAMME DURING THE
WASH CYCLE
PAUSE/INTERRUPT A PROGRAMME
CANCEL PROGRAMME
