Instructions for the user
30
5. USING THE HOB
Before lighting the hob burners, check that the flame-spreader crowns are
correctly in place with their respective burner caps, making sure that the holes
A
in the flame-spreaders are aligned with the igniters and thermocouples.
For the UR2 double burner, place and fit perfectly the burner caps
G
and
E
on
the flame-spreader crowns
F
and
D
. The latter have to be placed on support
C
and then fitted in the base
B
. The supplied pan stand
H
is for use with woks.
5.1
Lighting the hob burners
The burner controlled by each knob is shown next to the knob.
The appliance is equipped with an electrical ignition device.
Simply press the knob and turn it anti-clockwise to the maximum
flame symbol
, until the burner lights.
After lighting, keep the knob pressed down for a few seconds to allow the
thermocouple to heat up. The burner may go out when the knob is released: in
this case, the thermocouple has not heated up sufficiently.
Wait a few moments and repeat the operation, keeping the knob pressed for
longer. Once the burner is lit, the flame can be adjusted as required.
Always check that the control knobs are in the
O
(off) position when you finish
using the hob.
If the burners should go out accidentally, after about 20 seconds a safety device
will be tripped, cutting off the gas supply, even if the gas tap is open. In this
case, turn the knob to the OFF position and wait at least 60 seconds before
trying to light the burner again.
