Instructions for the installer
EN
40
11.7 Electrical connection
Make sure the voltage and the cross-section of the power supply line match the
specifications indicated on the identification plate positioned on the appliance.
Do not remove this plate for any reason. A copy of the plate is attached to the
instructions.
The appliance must be connected to the power supply by a qualified technician.
Before performing any operations, switch off the power supply to the appliance.
The appliance must be connected to earth in compliance with electrical system
safety standards.
Where the appliance is connected to the power grid via plug and socket, both of
these must be of the same type and connected to the power cable in
accordance with current standards. The socket must be accessible after the
appliance has been built in.
NEVER UNPLUG BY PULLING ON THE CABLE.
Should the earthing wire need replacing it must be longer than the conducting
wires so that, if the plug is torn off the power cable, it is the last to be detached.
Avoid use of adapters and shunts as these could cause overheating and a risk
of burns.
If a fixed connection is being used, fit the power line with an omnipolar circuit
breaker with a contact opening gap equal to or greater than
3 mm
, in an easily
accessible position close to the appliance.
The manufacturer declines all responsibility
for damage to persons or things
caused by non-observance of the above prescriptions or by interference with
any part of the appliance.
Summary of Contents for Oven
Page 43: ......
Page 44: ...914774767 A ...
