Smeg KSEGU24X, Instruction Manual, Page: 8 / 11

EN 8
SNAP-ON FITTING
• The hood can be installed either directly on the bottom
surface of the wall units using snap-on side supports.
• Cut a fitted opening in the bottom surface of the wall
unit, as shown.
• Insert the hood until the side supports snap into place.
• Lock in position by tightening the screws Vf from un-
derneath the hood.
SCREWS FITTING
• The hood can be installed either directly on the bottom
surface of the wall units (min. 25-9/16” above the hob).
• Cut a fitted opening in the bottom surface of the wall
unit, as shown.
• Fix using the 8 screws L provided.
EN
99
INSTALLATION
SNAP-ON FITTING
• The hood can be installed either directly on the bottom surface
of the wall units using snap-on side supports.
• Cut a fitted opening in the bottom surface of the wall unit, as
shown.
• Insert the hood until the side supports snap into place.
• Lock in position by tightening the screws
Vf
from underneath
the hood.
SCREWS FITTING
• The hood can be installed either directly on the bottom surface
of the wall units (min. 25-9/16” above the hob).
• Cut a fitted opening in the bottom surface of the wall unit, as
shown.
• Fix using the 8 screws L provided.
EN
99
INSTALLATION
SNAP-ON FITTING
• The hood can be installed either directly on the bottom surface
of the wall units using snap-on side supports.
• Cut a fitted opening in the bottom surface of the wall unit, as
shown.
• Insert the hood until the side supports snap into place.
• Lock in position by tightening the screws Vf from underneath
the hood.
SCREWS FITTING
• The hood can be installed either directly on the bottom surface
of the wall units (min. 25-9/16” above the hob).
• Cut a fitted opening in the bottom surface of the wall unit, as
shown.
• Fix using the 8 screws L provided.
EN
99
INSTALLATION
SNAP-ON FITTING
• The hood can be installed either directly on the bottom surface
of the wall units using snap-on side supports.
• Cut a fitted opening in the bottom surface of the wall unit, as
shown.
• Insert the hood until the side supports snap into place.
• Lock in position by tightening the screws Vf from underneath
the hood.
SCREWS FITTING
• The hood can be installed either directly on the bottom surface
of the wall units (min. 25-9/16” above the hob).
• Cut a fitted opening in the bottom surface of the wall unit, as
shown.
• Fix using the 8 screws L provided.