Installation
49
EN
Access via the rear casing
To connect the power cable, remove the
fastening screws on the rear casing as
shown in the figure.
Fixed connection
Fit the power line with an all-pole circuit
breaker with a contact separation distance
sufficient to provide complete disconnection
in category III overvoltage conditions,
pursuant to installation regulations. The
disconnection incorporated in the fixed
wiring must be compliant to AS/NZS 3000
regulations.
5.7 For the installer
• The plug must remain accessible after the
installation is complete. Do not kink or
trap the mains connection cable.
• The appliance must be fitted according
to the installation diagrams.
• Do not attempt to turn or stress the
threaded elbow on the manifold. You risk
damage to this part of the appliance
which may void the manufacturer’s
warranty.
• Before leaving check all connections for
gas leaks with soap and water. DO
NOT use a naked flame for detecting
leaks.
• Ignite all burners individually and
concurrently to ensure correct operation
of the gas valves, burner and ignition.
• Turn the gas knobs to the low position
and observe stability of the flame for
each burner individually and all together.
• In case the appliance fails to operate
correctly after all checks have been
carried out, refer to the Authorised
Assistance Centre in your area.
• When satisfied with the appliance,
please instruct the user on the correct
method of operation.
• If this cooking range is to be connected
to a new or upgraded electrical
installation, then it must be connected by
a supply cord fitted with:
- An appropriate rated plug that is
compatible with the socket-outlet fitted
to the final sub-circuit in the fixed wiring
that supplies this cooker.
- An appropriate rated installation male
connector that is compatible with the
installation female connector fitted to
the final sub-circuit in the fixed wiring
that supplies the cooker.
Summary of Contents for FSP9610X-1
Page 48: ......
