Instructions for the user
20
7. USE OF THE HOB
7.1 Lighting of the hob burners
Before lighting the hob burners check that the flame caps are in the
correct position and that their burner caps are in place, making sure that
the holes
A
in the flame caps correspond to the spark plugs and
thermocouples.
Before lighting the burners
lift the glass cover
; before lowering the
cover, turn off all the burners and wait for them to cool down.
The optional grid
B
is for use with “woks” (Chinese pans).
To prevent deterioration of the hob we have equipped the cooker with a
raised pan stand
C
to be placed underneath pans more than 26 cm in
diameter.
The supplied reduction rest
C
is also used for small pans.
The drawing next to each knob shows the
corresponding burner. The appliance has an
electronic lighting device. Simply press and turn the
knob anticlockwise to the minimum flame symbol
, until the ring is lit. Hold the knob down for a few
seconds to allow the thermocouples to heat up.
The burner may go out when the knob is released:
this is because the thermocouple has not been
sufficiently heated. Repeat the operation holding
down the knob for a little longer. This operation is
not necessary for burners without thermocouples.
For models with thermocouples, if the burner should accidentally go out,
a safety device will be activated which stops the gas flow even if the tap
is open.
Summary of Contents for FS61XPZ5
Page 30: ...Cod 914772552 A...
