Smeg DI614, Instruction Manual

Page: 39 / 45

EN
39
Instructions for the User
11 . Troubleshooting
The dishwasher has an autodiagnosis system capable of detecting
and indicating a preset series of possible malfunctions.
If a malfunction occurs, the relative name indicating the possible
cause of the malfunction appears on the
DISPLAY (G) . The
following table summarises the main possible malfunctions and
provides brief descriptions.
TABLE OF MALFUNCTIONS DETECTED BY THE
AUTODIAGNOSIS SYSTEM
MALFUNCTION - DESCRIPTION
Acquastop failure
The anti- fl ooding system has been activated (for the relevant
models only). The system is tripped in case of water leaks. Contact
the after-sales service.
Safety device tripped
The system which limits the water level inside the dishwasher has been
tripped. Interrupt the programme and switch off the dishwasher. Switch
the dishwasher back on, programme it again and start the washing
cycle. If the problem persists, contact the after-sales service.
Heating k.o.
The water is not heated or the heating parameters are not correct.
Repeat the washing programme; if the problem persists, contact
the after-sales service.
Temperature sensor k.o.
Interrupt the programme and switch off the dishwasher. Switch the
dishwasher back on, programme it again and start the washing
cycle. If the problem persists, contact the after-sales service.
Tap turned off
The appliance does not take in water or does not do so correctly.
Check that the water connections are correct, the water intake tap
is turned on and the
fi lter is not fouled. If the problem persists,
contact the after-sales service.
Drain blocked
If the appliance does not pump out the water or does not do so
correctly. Check that the drain hose is not kinked or crushed and
that the syphon and
fi lter are not fouled. If the problem persists,
contact the after-sales service.