Smeg CMS4104N, Instruction Manual

Page: 13 / 32

13
EN
Making coffee using coffee beans
Important!
Do not use green, caramelised or candied coffee beans as they
could stick to the coffee mill and make it unusable.
1. Fill the beans container (A16) (fig. 12) with coffee beans;
2. Place a cup under the coffee spout (A13);
3. Lower the spout so that it is as near as possible to the cup
(fig. 13): this helps achieve a better cream;
4. Press (B10) or (B8) until the required coffee is
displayed;
5. Then select your required coffee from the homepage:
• ESPRESSO
•
• COFFEE
• LONG
• 2 X ESPRESSO
• AMERICANO
6. Preparation begins and the display (B) shows the image of
the selected beverage together with a progress bar which
gradually fills as preparation proceeds.
Please note:
• It is possible to prepare 2 cups of ESPRESSO coffee at the
same time by also pressing X2 during preparation of
1 ESPRESSO (the image remains shown on the display for a
few seconds at the start of preparation).
• While the machine is making coffee, delivery can be inter-
rupted at any time by pressing .
• As soon as delivery has ended, to increase the quantity of
coffee in the cup, just press : once the desired
quantity is reached, press .
Once the coffee has been made, the appliance is ready to make
the next beverage.
Please note:
Various alarm messages may be displayed while using the
appliance (FILL TANK, EMPTY GROUNDS CONTAINER, etc.).
Their meaning is explained in section “Displayed messages”.
• For hotter coffee, see paragraph “Tips for a hotter coffee”.
• If the coffee comes out in drops, too weak and not creamy
enough or too cold, read the tips in section “Adjusting the
coffee mill” and the “Troubleshooting” chapter.
• Preparation of each coffee can be customised (see sections
“Customising beverages” and “Memorising your personal
profile”).
• If "Energy Saving" mode is active, the first coffee may take
a few seconds before it is delivered.
Making coffee using pre-ground coffee
Important!
• Never add pre-ground coffee when the machine is off in or-
der to avoid it spreading through the inside of the machine
and making it dirty. This could damage the appliance.
• Never use more than 1 level measure (C2) or it could dirty
the inside of the coffee machine or block the funnel (A4).
Please note:
If you use pre-ground coffee, you can only make one cup of cof-
fee at a time.
1. Repeat Press
AROMA (B6) until the display (B) shows
(pre-ground).
2. Open the cover (A15) and the pre-ground door (A23).
3. Make sure the funnel (A21) is not blocked, then add one
level measure of pre-ground coffee (fig. 14).
4. Place a cup under the coffee spouts (A13) (fig. 13).
5. Then select your required coffee (ESPRESSO, COFFEE, LONG
etc.) from the homepage;
6. Preparation begins and the image of the selected beverage
appears on the display, together with a progress bar which
gradually fills as preparation progresses.
Please note:
• While the machine is making coffee, delivery can be inter-
rupted at any time by pressing .
• As soon as delivery has ended, to increase the quantity of
coffee in the cup, just press : once the desired
quantity is reached, press .
Once the coffee has been made, the appliance is ready to make
the next beverage.
Important!
Making LONG coffee :
Halfway through preparation, the display will show message
ADD PRE-GROUND COFFEE, MAXIMUM ONE MEASURING CUP.
Add one level measure of pre-ground coffee and press
.
Adjusting the coffee mill
The coffee mill should not require adjusting, at least initially,
because it has already been set by default in order to prepare
coffee correctly.
However, if after making the first few coffees you find that the
coffee is either too weak and not creamy enough or delivery is
too slow (a drop at a time), this can be corrected by adjusting the
grinding adjustment dial (fig. 11).
Please note:
The grinding adjustment dial must only be turned when the
coffee mill is in operation during the initial phase of coffee