Smeg ASC72S, User Manual

Page: 26 / 27

26 EN
6 Troubleshooting
Drying process takes too much time.
• Pores of the lint filter are clogged. >>>
Wash the lint filter with warm water.
• Filter drawer is clogged.
>>>
Clean the sponge and the filter cloth in the filter drawer.
• Ventilation grids on the front side of the machine are blocked.
>>>
Remove the
objects (if any) that block ventilation in front of the ventilation grids.
• Ventilation is not sufficient since the room where the machine is installed is
very small. >>> Open the door and window of the room to avoid the room
temperature increase too much.
• Lime deposit has built up on the dampness sensor. >>> Clean the dampness
sensor.
• Excessive laundry is loaded. >>> Do not load the dryer in excess.
• Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your
washing machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual dampness level.
• It is likely that the selected programme did not suit the laundry type.>>> Checking
the care labels on clothes, select appropriate programme for the laundry type or
use timer programmes in addition.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
• Filter drawer is clogged. >>> Clean the sponge and the filter cloth in the filter
drawer.
• Excessive laundry is loaded. >>> Do not load the dryer in excess.
• Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your
washing machine.
Dryer does not switch on or the programme does not start. Dryer does not start
when it is set.
• It is not plugged in. >>>
Make sure that the machine is plugged in.
• The loading door is ajar. >>> Make sure that the loading door is closed securely.
• Programme is not selected or the Start / Pause / Cancel button is not pressed.
>>> Make sure that the programme is selected and the machine is not in Pause
mode.
• Childproof Lock is activated. >>> Deactivate the Childproof Lock.
Programme is interrupted without any cause.
• Loading door is ajar. >>>
Make sure that the loading door is closed securely.
• There was a power failure. >>> Press Start / Pause / Cancel button to start the
programme.
• Water tank is full. >>> Drain the water tank.
Laundry has shrunk, become felted or deteriorated.
• A programme suitable for the laundry type is not used. >>>
Check the garment
tag and select a programme suitable for the fabric type.