SMCBR14
Cable/DSL Router User Guide
4
¾
POWER:
The Power plug is where you will connect the power adapter.
)
Note:
Please use the power adapter supplied with the SMCBR14 Cable/DSL Router, if you use
a different adapter, it may cause damage to the Router.
¾
RESET:
Use the button to
reset the router's factory defaults. There are two ways to
reset the router's factory defaults:
1. Use
the
Factory Defaults
function on
System Tools
->
Factory Defaults
page
in the router's Web-based Utility.
2. Use the Factory Default Reset button: Press the Reset button for five seconds
and then wait for the router to reboot.
)
Note:
Ensure the router is powered on before it restarts completely.
¾
WAN:
One RJ45 port for connecting the router to a cable, DSL modem or Ethernet
¾
4/3/2/1:
Four LAN 10/100Mbps RJ45 ports for connecting the router to the local PCs
2.2 System Requirements
¾
Broadband Internet Access Service (DSL/Cable/Ethernet)
¾
One DSL/Cable modem that has an RJ45 connector (It’s not necessary if you
connect the router to Ethernet)
¾
Each PC on the LAN needs an Ethernet Adapter and an Ethernet cable with RJ45
connectors
¾
An operating system supporting the TCP/IP protocol
¾
Web browser, such as Microsoft Internet Explorer 5.0 or later, Netscape Navigator
6.0 or later
2.3 Installation Environment Requirements
¾
Not in direct sunlight or near a heater or heating vent
¾
Not cluttered or crowded. There should be at least 2 inches (5 cm) of clear space on
all sides of the router
¾
Well ventilated (especially if it is in a closet)
¾
Make sure the cables and power cord are placed safely out of the way so they do
not create a tripping hazard
2.4 Connecting the Router
Before you install the router, you should connect your PC to the Internet through your
