![background image](http://html1.mh-extra.com/html/smc-networks/smc8024l2/smc8024l2_management-manual_1300385018.webp)
C
ONFIGURING
THE
S
WITCH
10
is attached. (Note that the management station must always be on VLAN
1) Valid IP addresses consist of four numbers, 0 to 255, separated by
periods.
• Subnet Mask
– This mask identifies the host address bits used for
routing to specific subnets. (Default: 255.255.255.0)
• Gateway IP Address
– IP address of the gateway router between the
stack and management stations that exist on other network segments.
(Default: 0.0.0.0)
• MAC Address
– The physical layer address.
Port Information
• Type
– Indicates the port type.
• Link Status
– Indicates if the link is Up or Down.
• Speed/Duplex Status
– Shows the current speed and duplex mode.
Displays a number, the speed in Mbps, followed by either "fdx" for
full-duplex or "hdx" for half-duplex.
• Flow Control Status
– Indicates whether flow control is enabled or
disabled.
• Autonegotiation
– Shows if auto-negotiation is enabled or disabled.
• Frame Type
– Either "Tagged" or "All". "Tagged" means that the port
will only send and receive VLAN-tagged packets. When set to "All", the
port will also send and receive untagged packets.
• PVID
– VLAN ID assigned to untagged frames received on the
interface. (Default: 1)
Trunk Information
• Trunk
– The trunk label. "T1" through "T8" are used as trunk labels.
• Type
– All trunks and ports on this switch are 10/100/1000M
• Trunk Status
– An indication of the speed and duplex setting of the
trunk. This is a number, the speed in Mbps, followed by either “Full” for
full-duplex or “Half” for half-duplex. This can be changed on the
TRUNKS > Settings page.
• Ports
– The ports that are members of the trunk.