![background image](http://html1.mh-extra.com/html/smc-networks/smc6709gl2/smc6709gl2_management-manual_1300373084.webp)
C
ONSOLE
I
NTERFACE
4-16
Configuring Interface Connections
Use the Port/Trunk Configuration page to enable/disable an interface, set
auto-negotiation, or manually set the speed and duplex mode, and flow
control parameters.
Field Attributes
•
Type
– Shows port type (page 4-7).
•
Enabled
– Allows you to manually disable an interface. You can disable
an interface due to abnormal behavior (e.g., excessive collisions), and
then reenable it after the problem has been resolved. You may also
disable an interface for security reasons.
•
Auto Negotiate
– Enables/disables auto-negotiation.
•
Speed/Duplex Config
– Manually sets port speed and duplex mode.
•
Flow Control
– Allows automatic or manual selection of flow control.
Flow control can eliminate frame loss by “blocking” traffic from end
stations or segments connected directly to the switch when its buffers
fill. When enabled, back pressure is used for half-duplex operation and
IEEE 802.3x for full-duplex operation. (Avoid using flow control on a
port connected to a hub unless it is actually required to solve a problem.
Otherwise back pressure jamming signals may degrade overall
performance for the segment attached to the hub.)
•
Group
– Assigns a port to a trunk group. (Range: 1-4)
To set a trunk as a dynamic link, use the LACP menu (page 4-52).
Note:
Auto-negotiation must be disabled before you can manually force
a port to use the speed/duplex mode or flow control options.
Summary of Contents for SMC6709GL2
