Fully covers a pressure force
Low Friction Cylinder
Series
MQP
Series
Series
MQP
MQP
Features
3
Even extremely small degree lurching
such as 0.01 mm does not occur. In
addition, special air supply to a
bearing for fluid is unnecessary.
No lurching
No lurching
Dispersion of piston diameter: 3 m or less
Readjusting thrust is not necessary
when the cylinder is replaced.
Dispersion of thrust does not occur even
more than one cylinder is connected to
the same circuit, either. (Depends on the
operation environment.)
Reduced thrust
dispersion
Reduced thrust
dispersion
Possible to control the output in
increments of 0.01 N. (Depends on
the piston area of a cylinder x
pressure accuracy)
In addition, sliding resistance does
not change after periods of
non-operation.
Low friction and
soft-touching
Low friction and
soft-touching
Delicate and precise linear movement
control is possible.
High-precision
linear control
High-precision
linear control
Sliding resistance is drastically
decreased because the piston and
the rod share the same shaft.
No piston
No piston
Special single acting/Piston
retraction by external force
Special single acting/Piston
retraction by external force
Series
MQP
Low friction cylinder suitable for low friction, force control.
Bore size [mm]
(Pressure receiving diameter)
ø 4
ø 6
ø10
ø16
ø20
Weight of moving parts
[g]
4
8
24
62
103
Thrust control standard
[N]
0.01 to 8
0.03 to 19
0.08 to 50
0.20 to 140
0.30 to 200
Stroke [mm]
10
Operating pressure range
[MPa]
0.001 to 0.7
(Excluding the weight of
moving parts)
For force control
External force
Piston rod: Special stainless steel
(Metal seal)
The inside of the rod is hollow to
reduce the weight of moving parts.
No piston
Liner: Special stainless steel
(Metal seal)
The special shape rod end is
not easily effected by an
offset load generated by
mounting inaccuracy.