IN19856
- 9 -
Rev 2
▪
Stop operation if the equipment does not function properly.
▪
Otherwise safety is not assured due to an unexpected malfunction or incorrect
operation.
o
Do not use solvents such as benzene, thinner etc. to clean the unit.
▪
They could damage the surface of the body and erase the markings on the body. Use a
soft cloth to remove stains. For heavy stains, use a cloth soaked with diluted neutral
detergent and fully squeezed, then wipe up the stains again with a dry cloth.
2.
About this Manual
The purpose of this manual is to provide the user with necessary information to install, configure,
and use the ITV####
–
SEN
–
##
–
DUX02357
–
#### also known as the Ethernet ITV.
The ITV is typically operated under the control of a master device (usually a PLC). The ITV may also
be operated under the control of explicit messaging program Ex:
LabVIEW™ software
. Finally, the
ITV may be operated using the built-in ITV web interface. Examples for each of these conditions are
documented in this manual.
This manual provides information for ITV setup and configuration, examples of the web interface, a
LabVIEW™ software
program, and a brief overview of the Rockwell Automation® RSLogix 5000®
software.
Please see the manufacturer’s documentation for detailed instructions on the setup and
use of your Rockwell Automation® or other PLCs. Please see the
LabVIEW™ software
documentation for more information on using
LabVIEW™ software
.
3.
Terminology
Terms
Meaning
A
Auto negotiation
The function that automatically optimizes the common communication parameters such as speed,
duplex mode, and flow control between Ethernet devices.
B
Bus In / Bus Out
M12 Ethernet communication connectors located on top of the ITV.
C
Counts
The ITV controls and reports pressure or vacuum internally in
Counts
. The counts are used by
hardware devices to control and measure the pressure or vacuum regulated by the ITV.
Current
consumption
The current necessary to operate each unit or device using a 24 VDC.
