11. Specification for Option T
11- 2
11.4 How to connect the power and signal cable
Connect the power cable and signal cable in the following procedures.
1) Take off the rear panel.
2) Insert the power cable prepared by the customer into the power cord inlet (with rubber grommet) and
bring the power cable near the terminal block through the base hole.
3) Connect the power cable to the terminal.
4) Insert the signal cable prepared by the customer into the signal cord inlet (with rubber grommet) and
bring the signal cable near the terminal block.
5) Connect the signal cable to the each terminal.
6) Put back the rear panel.
Rear panel
You can see the terminal block when you
remove this cover.
To the user’s machine
N
L
Failure
PE:Ground
Operation
1 2 3
L,N:Power supply
PE
Front
Terminal connecting screw: M3
Crimped terminal width: 6.5mm or less
Applicable electric wire: 1.25mm
2
or more
Rubber grommet
Power supply cable entry
Rubber grommet
Signal cable outlet
