SMC Networks IDFB60-23-C, Operation Manual, Page: 14 / 52

IDX-OM-V024
Chapter 3 Transportation and installation
3.2
Installation
IDFB60/70/80/90 Series
3-2
3.2 Installation
3.2.1 Environment
Do not use in the following environments, as it may lead to a breakdown. Potential malfunction or
damage to the product may occur if these instructions are disregarded.
- Avoid locations where the air dryer will be in direct contact with wind or rain. (Avoid locations where
relative humidity is 85% or more)
- Avoid locations where water, water vapor, salt water, or oil may splash on the product.
- Avoid locations where dust or other particles are present.
- Avoid locations where flammable or explosive gases are present.
- Avoid locations where corrosive gases, solvents or combustible gases present.
- Avoid locations which receive direct sunlight or radiated heat.
- Avoid locations where the ambient temperature exceeds the limits as mentioned below.
During operation: 36 to 113
o
F (2 to 45
o
C)
During storage: 32 to 122
o
F (0 to 50
o
C) (when there is no drain water inside of the piping)
- Avoid locations where temperature substantially changes.
- Avoid locations where strong magnetic noise occurs. (Avoid locations where strong electric field,
strong magnetic fields, or surge voltage occur).
- Avoid locations where static electricity occurs or conditions which make the product discharge static
electricity.
- Avoid locations where high frequencies occur.
- Avoid locations where damage is likely to occur due to lightening.
- Avoid installation on machines used for transporting, such as vehicles, ships, etc.
- Avoid locations at altitudes of 2000 meters or higher.
- Avoid locations where strong impacts or vibrations occur.
- Avoid locations where a massive force strong enough to deform the product is applied or the weight
from a heavy object is applied.
- Avoid locations with insufficient space for maintenance.
Necessary maintenance space
Front: 2feet (600 mm)
Back: 2feet (600 mm)
Top: 2feet (600 mm)
Right side: 2feet (600 mm)
Left side: 2feet (600 mm)
- Avoid locations where the ventilation grille is obstructed.
- Avoid locations where the air dryer will draw in high-temperature air discharged from an air
compressor or other dryer.
- Avoid pneumatic circuits where rapid pressure fluctuations or flow speed changes are generated.
3.2.2 Anchorage
- The product should be installed on a vibration-free, stable, horizontal flat surface.
- Refer to the 7 Dimensions of the Chapter 7.3.
- We recommend the anchor bolt sets that is sold separately as an accessory.
Product No. Product name QTY.
IDF-AB500 Set of foundation bolts 1 (4pcs./ set)
- Do not use or store the product in conditions of compressed air or an environment
containing substances below. Otherwise, malfunction or parts damage may occur.
- Corrosive gas, organic solvents or chemicals.
WARNING