SMC Networks 2621W-P, User Manual, Page: 15 / 133

Chapter 2 LAN Installation
10
3. Connect the Network Cable
Connect the network cable to the 10/100BASE-T LAN connector
on the Wireless Print Server.
4. Power Up
Plug in the power adapter cable and power up. Start-up will take
only a few seconds.
Use only the Power Supply unit provided with the device.
Power Supply units for different models are not
interchangeable.
5. Check the LEDs
•
The Red Error LED should flash, then turn Off. When the
Error LED goes off and the ACT LED remains lit or flashes,
the Wireless Print Server is ready.
•
For model SMC2621W-U, the Red Error LED will remain
flashing if the Wireless Print Server can't connect to the
USB printer.
•
The LAN LED should be ON.
(The WLAN LED will be Off. This is normal, see the
explanation above.)
Note: This will disable the Wireless interface. The Wireless
interface cannot be used for initial configuration.
•
After configuration, the LAN interface can be
disconnected if not required.
•
To use both the LAN and Wireless interfaces, the
Wireless mode must be changed to "Ad-Hoc".
•
To use the LAN interface, the LAN cable needs
to be inserted BEFORE powering ON.