3-10
I
NSTALLING
AND
C
ONFIGURING
N
ETWORK
D
RIVERS
5. At this point, a protocol must be bound to the driver. For
example:
BIND IPX TO SMCPWR2 NET=XX
where xx is the logical network address for the frame type
indicated in your load command.
Driver Command Line Parameters
Optional command line parameters are described in the NetWare
4.x server driver installation document on the SuperDisk.
Note that the network card is preprogrammed with Auto Negotiate
on the UTP port as the default configuration. The preprogrammed
configuration can be changed by running EZStart. Some command
line parameters are used to override the default configuration. In
the absence of such parameters, the default configuration will be
used by the NetWare driver.
DOS ODI VLM Client Driver
There are three different methods you can use to install the DOS
ODI driver and a VLM client:
One Step Installation with EZdosodi
In one simple step EZdosodi™ will attach your computer to the
nearest NetWare server. It will automatically detect your
network's frame type and configure your client files accordingly.
It will also modify your CONFIG.SYS file to add the
LASTDRIVE=Z statement and the AUTOEXEC.BAT file to call
STARTNET.BAT which calls the NetWare client files that attach
your workstation to the network server. If you do not wish to be
automatically connected to a network server at this time, use
one of the two installation procedures described on the following
pages. Otherwise, refer to the EZSTART.DOC document on the
SMC SuperDisk for information about how to use EZdosodi (Exit
to a DOS prompt, change to the SuperDisk target drive, type
“EZDOSODI,” and press “Enter”).
Summary of Contents for SMC9432BTX
