7
Programming the Device for Model Mode or Disable Features
Place the unit in Model Mode / Disable Features Program Mode:
Hold the
Water Only
&
Empty Only
buttons down together for 3 seconds. The Holding
Tank Full LED will give three flashes indicating you have entered program mode. While
still holding down these two buttons, press the
Normal Flush
button. The Tank LED will
give six flashes indicating you have entered Model Mode / Disable Features program
mode, release both buttons.
Selecting Model Mode:
Press the
Normal Flush
button, the Holding Tank Full LED will give four flashes
indicating you have entered program Model Mode.
You may now select which Model Mode you require: Press the
Normal Flush
button for
Tecma
Silence
(Series)
(model mode 2), the
Empty Only
button for
Standard Mode
(model mode 1) or the
Water Only
button for extended models, press the
Normal Flush
for
Tecma
Prestige (Series)
(model mode 3)
or
the
Water Only
button for
European
Mode
(model mode 4). The Tank LED will give three flashes indicating you have finished
model program mode.
Disable Features:
You can disable or enable two features:
1/
The Manual buttons
. If disabled the only button that will work is the Flush button. The
Water Only
and
Empty Only
buttons will be disabled
.
2/
Tank Full. If enabled and the tank is FULL the LED will be turn on and NO
buttons will work. If disabled and the Tank is FULL the LED will be on and ALL
buttons will still work.
3/ Deactivation of the
Water Only
button after use. If this feature is enabled then after
the
Water Only
button has been pushed and released it will be deactivated. The
Empty
Only
button will need to be pressed for at least 1 second to reactivate the
Water Only
button. This feature can be disabled or enabled.
Place the unit in Model / Disable Features Program Mode as above (top of page).
Push the
Empty Only
button, the holding tank full LED will give three flashes indicating
you have entered disable feature mode.
You may now select which feature to disable.
1/ Push the
Normal Flush
button disable or enable the Tank Full feature.
2/ Push the
Water Only
button to disable or enable the Manual buttons.
3/ Push the
Empty Only
button to disable or enable the
Water Only
button deactivation
feature.
The Tank LED will give three flashes indicating you have finished model program mode.
Repeat the step to re enable these features.
NOTE:
The factory default setting is on for both of these features.
