iSmartATF 501 Auto Transmission Cleaner and Fluid Exchanger User’s Manual
11
Fig.25
2) Input the amount to be filled, press ENTER key. As
shown in Fig.26
Fig.26
3) When the recharging is completed, the system will
automatically pop up print menu. Press ENTER key
select print, press RETURN key to cancel printing.
Refer to Fig.27
Fig.27
5.2 Decrease fluid amount
If the quantity of the ATF is more than the standard
amount, it is necessary to decrease the fluid amount
inside transmission (Lower the fluid level).
1) Enter the menu of Adjust fluid level, select ‘Draining’,
it indicates that the fluid inside transmission is being
drained, as shown in Fig.25.
2) Input the amount to be drained, press ENTER key,
and then start the engine, the unit will drain the set
quantity of ATF to used fluid tank.
3) After the adjustment is completed and the unit will
prompt to finish. The system will automatically return
to the main menu.
6. Empty new fluid tank
5)
Be sure that the two hoses marked with “TO
TRANSMISSION” are not connected with the vehicle
to be maintained.
6)
Open the handle valve on the fluid hose marked with
“EMPTY”, and then place the hose into container.
7)
The system will enter into the interface for Empty
new tank, and automatically start fluid draining
operation, as shown in Fig.28.
Fig.28
8)
The unit will drain fluid until the hose marked with
“Empty” has no oil draining or press RETURN key to
stop draining operation.
7. Empty used fluid tank
1) Be sure that the two hoses marked with “TO
TRANSMISSION” are not connected with the vehicle
to be maintained.
2) Open the handle valve on the fluid hose marked with
“EMPTY”, and then place the hose into container.
3) The system will enter into the interface for Empty
used tank, and automatically start fluid draining
operation.
4) The unit will drain fluid until the hose marked with
“Empty” has no oil draining or press RETURN key to
stop draining operation.
8. System setting
1) Select system setting item in main menu, press
ENTER key.
2) In the sub-item of system setting, select the desired
setting item. The interface is as shown in Fig.29(a)
and Fig.29(b).
Fig.29(a)
