10
OPERATION
(Check off box when complete)
Run the car and verify the following:
No Faults
Make sure the car is moving without triggering a fault either
on the Smartrise SRU or the drive. If the SRU board displays a
“Drive Fault” on the SRU, look at the drive to see what the
fault is. The most common fault is “Encoder Flt”.
o
Go to “
Troubleshooting – Drive Fault / Encoder Flt
” for
corrective actions.
Proper Direction
Make sure the car is moving in the same direction as the
control switch on the Run Bug.
o
Go to “
Troubleshooting – Wrong Direction
” for corrective
actions.
At Speed
Make sure that the car is moving at the proper inspection
speed (approx. 50 FPM).
o
Go to “
Troubleshooting – Car Moving Too Slow or Rough
”
for corrective actions.
Under Control
Make sure that the car is moving under full control. The car
should stop when commanded from the Run Bug. Verify that
the car runs with no faults for 10 seconds or more.
o
Go to “
Troubleshooting – Brake Not Lifting
” for corrective
actions.
