Smart Power Systems
®
A. C. MODULAR GENERATOR SYSTEM
Page 30 of 56
assembly. If the air is not being pushed through the cooler face contact Smart Power
Systems
®
at (231) 832-5525 for more information. Also verify that the air passing
through the cooler and the fan is not restricted.
WARNING:
The SPS Model HR-6.2, HR-8, HR-10 and HR-110 have been pre-set at the factory to
provide correct frequency and voltage. No pump adjustment is required. If it appears
the pump needs to be adjusted, contact Smart Power Systems
®
at (231) 832-5525
before proceeding. Damage to generator from improper pump adjustment will void
the system’s warranty.
Improper ventilation will result in system overheating, reduced performance and
possible damage to the system and/or cause personal injury. If the system is
installed such that improper ventilation exists, the system’s warranty will be voided.
12.
Set “auto-start” option.
If the auto-start option is enabled, the generator will begin generating electricity
whenever the PTO is engaged. If the auto-start option is disabled, the generator will
not output electricity after PTO engagement until the “on/off” button is pressed. Select
the auto-start function by performing the following steps:
Step b: Hold Mode until
Amps Line 1 Blinks
.
Release switch so
and
appear.
Step c: Press On/Off
until the desired value
appears
Figure 15
– Auto-start Selection
