HGM6100K Series Automatic Generator Module
HGM6100K Series Automatic Generator Module ISSUE 2011-04-12 Version 1.6 Page 24 of 31
8 PARAMETER SETTING
After controller powered on, press
to enter into the parameters setting menu:
1 Set Parameters.
2 Information.
3 Set Languages.
■ Set parameters
When entering password, entering "1234" can set the item 1 to 38 in the table
(parameters table [Table 1]), entering "0318" can set all items.
NOTE:
a
．
When the controller type is HGM6110KC, you will not have a table with a 1-5;
the programmable output 1-4 will have no power of some mains switch output.
b
．
Please modify the parameters (such as crank disconnect, input and output
configuration, various time, etc.) in standby mode, otherwise it might alarm
shutdown or other abnormal behavior.
c
．
The over-voltage threshold must be greater than the under-voltage threshold;
otherwise both will occur at the same time over-voltage and under-voltage
situation.
d
．
The over-speed threshold must be greater than under-speed threshold,
otherwise you will receive both the over speed and under speed.
e
．
As far as possible set the frequency (crank disconnect) to lower numerical, in
order to quickly crank disconnect when crank success.
f
．
Configurable input port 1-5 cannot set for the same items, otherwise cannot
appear correct function, configurable output 1-4 can be set for the same item.
g
．
If need to shutdown after cooling, please set any one configurable input as "
stop after cooling ", then connect this input with GND.
■ Information
LCD will display the controller software version, issue date.
Note:
Press the key
will display the states of switching input 5 whether or not
active.
