Smarter JS-6000, User Manual

Page: 8 / 12

USER’S MANUAL PAGE 8 JS-6000
of engine cranking. The jumpstart feature is designed for short term
operation only, and more than 5 seconds may cause damage to the
unit. Allow the jump starter to cool down for at least 3 minutes after
each jumpstarting.
6) Disconnect the cable from the jump starter immediately after engine
starts, and then remove from battery terminals.
“BOOST” Mandatory Operations:
1) If with correct connection between Jump Starter and vehicle battery
(Red LED keeps on and green LED is off), press and hold BOOST
button for three (3) seconds (after a buzzer sound, the green LED
is on and red LED is off). Usually this is because the vehicle battery
capacity is rather low.
2) Start the engine (same method as the normal operations in Page 7).
Cautions:
1) Under normal circumstances, do not use the mandatory operations.
2) The spark proof, reverse polarity protection and short circuit
protection features are disabled after Boost button is pressed. Pay
very close attention to the polarity of the battery before using this
mode. Do not allow the positive and negative battery clamps to touch.
CHARGING
This product is partially charged from the manufacturer. Fully charge the
unit immediately after purchase. In order to prolong the product life, be sure
to fully recharge the unit after each jumpstaring, or every 3 months even if
this unit has not been used. If battery voltage in the jump starter is too low,
this item will shut off to prevent damage to itself. Recharge the unit as soon
as possible to be activated and fully charge it to ensure long battery life. In
addition, we recommend not to charge and discharge the unit at the same
time.
AC Charging:
1) Insert AC charging adapter into charging jack of the unit.