USER’S MANUAL PAGE 9
JS-6000
2) Plug the other end of AC charging adapter into a wall socket.
3) Fully charge the unit.
4) When charging is complete, unplug the AC charging adapter from the
wall socket first, then from the charging jack on the jump starter.
DC Charging in Your Vehicle:
1) Turn the vehicle engine on.
2) Insert the DC charging adapter into the charging jack of the unit.
3) Plug the other end of DC charging adapter into vehicle’s cigarette
lighter socket.
4) Fully charge the unit. Engine must keep running during entire charge.
5) When charging is completed, unplug the DC charging adapter from
the vehicle first, then from the charging jack on the jump starter.
Charging Time:
LCD will show “100%” as fully charged. Charging time will differ based on
the discharge level and the power source used. If charging begins from 5%
to full charge, it approximately takes 3 hours for AC charging.
USB POWER
Connect the USB device to the jump starter with either the original cable or
the included multi-tip cable (better use original cable of Apple® for Apple®
products). Press Power button to start USB power. When disconnected,
the jump starter will automatically shut off. The number of times you can
recharge a USB device will vary between devices.
FLASHLIGHT
Press and hold Power button for 3 seconds to start flashlight. Press once to
switch lighting modes: Steady On – Strobe – SOS – Off.
SUPPLY TO 12V DEVICES
The jump starter can run/charge 12VDC appliances that draw 10 amps or
less. Connect the jump starter to 12V devices by the included accessory.
Do not need press Power button as the EC5 12VDC output is ALWAYS
activated. When battery voltage of jump starter is too low, 12V devices will
stop running/charging.
Summary of Contents for JS-6000
Page 12: ......
