Longo programmable controller LPC-2.DP1
below module and 1 cm off the wall.
Recommended installation height is 1.5 m above floor level.
1. Set the correct RS-485 address (S1 switch) for LPC-2.DP1 (refer to the Table 4).
2. Connect interconnection cable to the connector K1. Max. allowed tensile force is 30 N.
3. Put the LPC-2.DP1 in mounting frames.
4. Cover LPC-2.DP1 with cover plate.
LPC-2.DP1 is connected to the main module with interconnection cable (e.g., SSK, ICM-7) which
must be ordered together with LPC-2.DP1 module. When more modules (e.g., LPC-2.CR1, LPC-
2.CH1, LPC-2.DP2 or up to four LPC-2.DP1) are connected to main module, splitter (e.g., SPL-2) is
also required (Figure 2).
Module address on RS-485 network is set with DIP switch on the back of the module (Table 4).
NOTE
: Signal wires must be installed separately from power and high voltage wires in accordance
with general industry electrical installation standard.
11
