Comfort.me DUO
OPENTHERM
17
If the error code starts with the letter C, it is necessary to consult the boiler manual as the fault / message does not concern
the thermostat.
Note:
To reset a boiler error directly from the thermostat, simply hold down the
and
buttons at the same
time until the wording RST appears at the top left of the thermostat display.
Thermal curve configuration
Thanks to the Comfort.me DUO OpenTherm it is possible to configure the parameters of the thermal curve as desired in a
simple and fast way. By setting a high or low value, it is possible to heat the surrounding environment more or less quickly
respectively.
Note:
setting a high thermal curve value leads to higher consumption and lower energy savings.
To access the modification of the thermal curve, press M and simultaneously
for 6 seconds and enter the settings.
Each press of M will allow you to modify the parameter, position yourself on parameter 56, 58, 59, 60, 61, 64 and / or 67
and set the desired value (see the table on page 6).
Wiring diagram
Installation and measurements
Wall installation:
1.
Carefully separate the thermostat from the back cover. To do this it is necessary to pry into the gap between the two
parts with a small flat-blade screwdriver.
2.
Mark the position of the two fixing holes on the wall using the back cover as a template. Drill the points with the marks
and insert a dowel in each hole and screw the back cover firmly to the wall.
3.
Remove the battery cover and insert the battery and place the thermostat back on the cover fixed to the wall with a
light pressure.