Page 7
MNSNV102005Ver1.0
Connecting the SmartNet-V (Quick Start)
Warning: As a precaution, we recommend that you disconnect all power cords and make sure that
all devices are turned off.
1.
Plug in all external audio/video sources to the back of the SmartNet-V.
2.
Connect CAT5 (UTP) cables to the front of the unit and route the cables to the desired location
3.
Connect the receiver unit (SLI-RX100) to the end of the CAT5 cable.
4.
Connect Output monitor and speakers to the receiver Units.
5.
Connect RS232/RS422 adapter to the male serial port on your computer. Then connect the
RS422/RJ45 adapter to that first adapter
6.
Use CAT5 cable to connect the adapters (from computer) to the IN terminal (CAT5) on the front
panel of the SmartNet-V unit.
7.
Plug in all power adapters to the receivers as well as the SmartNet-V unit.
8.
Install SmartControl software.
9.
Power on the SmartNet-V Router.
Note: 2 adapters will be connected together. This is normal. RS232 to RS422 to RJ45.
Chapter 2: Installation
Chapter 2: Installation
Chapter 2: Installation
Chapter 2: Installation
Chapter 2: Installation
Summary of Contents for SmartNet-V
Page 4: ...Page 4 MNSNV102005Ver1 0...
