8
2. Hardware istallation
2.3 Placement
2.3.1 Wall mounting
Aside from desktop placement, you can install the
SAG-1010 vertically on a wall using the mounting
hook at the bottom side of the device.
To mount the device on a wall:
1. Tighten a screw on the wall until only 1/4 inch is
showing.
2. Latch the mounting hook on the screw.
2.3.2 Window mounting
Using the window mount sets, SAG-1010 can be installed on flat window class, and receive
wireless signals from either side of the window.
To mount the device on a window class:
1. Compose window mount set. Reverse the suck discs, if the signal is from the other side of the
window.
2. Compose the window mount set on the middle of the bottom of the device.
3. Press both suck discs onto the window class. Make sure the device does not fall before leave
you hands.
Adjust the screw if you cannot latch the device or if the device is too loose.
Mounting hook
