Hax Series Hanging Scale
5
2.4
Calibration Check
Hang a known weight on the machine and make sure that the scale reads the
correct weight on the display. In case of a variation in the display reading, it is
recommended to calibrate the scale again with the procedure explained in section
7.1 later in the manual.
3
CONTROLS & FUNCTIONS
SYMBOL
NAME
FUNCTION
Located on
back side of
scale
Power Switch
To power on and off the machine
HOLD
Right shift the selected digit during cal or
other setup modes
Holds the weight on the display
M+
Manual Accumulation, Add weight to
memory
Long press clears the Accumulated memory
Recall Accumulated weight
Increment digit by 1 of selected digit. Ex
change 0 to 1 to 2 to 3….9
MODE
Changes to different options available in the
setting mode
Press and switch on the scale, displays the
internal counts
TARE/ZERO
Tare / Zero the weight hanging on the hook
Zero the weight hanging on the hook.
Enter Key – Accept the selected setting and
exit from setting mode.
External Calibration of Scale
Hax Series Hanging Scale
6
4
USER OPERATION
4.1
SWITCHING SCALE - ON / OFF
The scale is switched ON / OFF by using the
Power switch located on the back side of the scale.
Note:
Make sure there is no weight hanged before turning on the scale.
4.2
TARE / ZERO
: The machine has a common Tare/Zero button.
TARE /
ZERO BUTTON: This button is used for taring a weight to display 0.00. Hang a
Bowl on the hook (say 200g), then press the TARE button. The weight is zeroed
and the machine will display zero.
4.3
ACCUMULATION
: Hang a weight on the Hook (ex 200g). The display will show
the weight. Now press M+. The display will show “n ...” total no. of items weighed
and then the total weight. Now hang another weight (ex 300g), the display will
show its weight, now press the M+ button, the display will show the no. of items
and the total weight. To recall the accumulated weight press the M+ button.
4.4
HOLD FUNCTION:
This function enables you to hold a particular weight that is
being displayed on the display of the scale so that the user can see the accurate
stable weight until the hanged weight is lifted back from the hook. To hold the
weight just hang some weight to the scale and press the “ M+ ” button and you
will notice the displayed weight has been hold with the hold led blinking, now
remove the hanged weight and the scale will automatically return to the
weighing mode.
4.5
MODE
This button is used to select the different values available in the scale
settings mode. This button is also used to display the internal counts. Press and
hold the button and switch on the scale until display shows the internal counts.