FRU-20-01032-20
Replacing the lamp on your
SMART Table™ ST230i
These instructions guide you through the replacement of the projector lamp in your
SMART Table™ ST230i. The average life of a projector lamp is 2000 hours. When the
projector lamp has been used for 2000 hours or more, the following message appears
on your SMART Table’s surface:
It is time to replace the lamp. Use the procedure in the User’s Guide to replace
the lamp as soon as possible.
After 2100 hours of use, the following message appears on your SMART Table’s
surface for 10 seconds, and then the projector turns off:
The lamp has exceeded its service life! The projector will not turn on until you
replace the lamp.
NOTE
In some situations, the projector lamp may start to dim before 2000 hours of use.
Replace the projector lamp in these situations as well.
To replace the lamp, you must:
•
disconnect the cables and vent hose from the projector (page 3)
•
remove the projector and bracket from inside the cabinet (page 5)
•
replace the projector lamp module (page 7)
•
reattach the projector to the bracket (page 9)
•
attach the cables and vent hose to the projector (page 9)
•
reset the lamp timer (page 10)
This Kit Contains
Tools Required (but not included)
• Replacement Lamp Module
• Phillips® No. 2 screwdriver
• 5 mm hex key
