Smart Technologies SMART Table ST203i, Instruction Manual, Page: 9 / 12

9 | FRU-20-01032-20 – REPLACING THE LAMP ON YOUR SMART TABLE ST230I
Replacing the Projector Assembly
Once the new lamp module is installed, replace the projector assembly on the
mounting bracket.
To replace the
projector assembly
1. Slide the slots through the pins located on the stationary mounting bracket.
2. Press down on the latch to lock it in place.
3. Replace the locking thumbscrews (see illustration on page 5).
4. Attach the vent hose to the projector (see illustration on page 4).
5. Connect all cables to the projector (see illustration on page 4).
6. Connect the power cord to the wall power outlet.
7. Reset the lamp timer (see page 10).
8. If required, adjust the projected image (see page 11).
A B