12
2000i-DVX Installation Guide
The projector is configured to shut down three minutes after no new input signal is received. For this
reason, you should avoid using the screen saver function on the computer. Of course, the only real
benefit of a screen saver – to avoid image burn-in, either on monitors or plasma displays – has no
bearing at all on a projected system.
During the three-minute shutdown period, the interactive screen turns black. If you want to use the
system again, you can restore the display by pressing any button in the Control Panel. At the end of
the shutdown period, the projector lamp turns off, and you must press the On button to restore the
system.
NOTE:
You can't adjust the power settings on Windows NT 4.0 systems, so at the end of the day you
must leave on with full power or shut it down.
To adjust a computer's default power settings (Windows)
NOTE:
This procedure may vary, depending on which version of the Windows operating system
you’re running.
1. Click the
Start
button on the Windows taskbar, point to
Settings,
and select
Control Panel
.
2. Double-click
Display
and click the
Screen Saver
tab.
3. Under
Energy saving features of monitor
, click the
Settings
(or
Power
) button.
The
Power Management Properties
(or
Power Option Properties
) dialog box appears.
4. Select
After 1 hour
from the
Turn off monitor
list.
NOTE:
This is a recommended setting. You can select any duration you want.
5. In the
Turn off hard disks
list, select the period of inactivity that must elapse before hard disk
shutdown.
NOTE:
For the above step, we recommend that you select
After 2 hours
. This extended time
period ensures that guest laptop presenters
−
or participants in lengthy meetings characterized
by large gaps in activity
−
do not experience an unexpected hard disk shutdown.
6. Click the
Apply
button and then click
OK
.
When the system reaches the period of inactivity specified in step 4, the computer stops sending
an RGB signal. If no other source is active, the projector goes into a three-minute shutdown
mode, during which time the screen turns blue (the no-input screen). After three minutes, the
projector lamp turns off and the screen turns black.
NOTE:
To immediately restore the input signal from the computer during this three-minute
projector shutdown period, press any Control Panel button. This function is especially handy
when you're a passive participant in a lengthy data conference.
Summary of Contents for SMART Board 2000i-DVX
Page 1: ...Interactive Whiteboard Guide Installation ...
Page 8: ......
