Important.
Use the supplied adhesive Epoxy 2K. Read the instructions supplied with the glue! From
each tube squeeze the same amount. Mix well about 1 minute. The transducer is applied onto the mixed
adhesive and pushed hard on the location of the bonding. The glue achieves hold within a few minutes.
Stabilize with a cross of adhesive tape (recommended). Adhesive reaches its strength after 1h.
Leave it
to dry for min. 1h at 20 deg. C. !
Apply a thin layer of contact grease OKS11 to the the transducer. Screw the transducer onto the adapt-
er. Fasten it tight to remove any air bubbles.
After 10 min. tight it again!
