THE GREASEBUSTER SKIMMER IS DESIGNED FOR THE REMOVAL OF SURFACE FATS, OILS AND
GREASE FROM TANKS AND SILOS.
THE GREASEBUSTER CONSISTS OF A HYDROSCOPIC BELT WHICH ATTRACTS OILS AND REJECTS
WATER. BY ROTATING THE BELT THROUGH THE FATS, OILS AND GREASE THE WASTE IS REMOVED
FROM THE SURFACE AND DEPOSITED IN A COLLECTION TRAY.
THE OPTIONAL PADDLE WHEEL HELPS TO BREAK UP SOLID FAT SURFACES AND PROMOTE THE
TRANSFER OF THE WASTE TOWARDS THE BELT.
A HEATER PLATE ENSURES THAT COLLECTED FATS AND GREASE DOES NOT SOLIDIFY IN THE
COLLECTION CHAMBER AND IS FREE TO RUN INTO A STORAGE VESSEL.
General Information
The information contained in this manual has been carefully checked and is believed to be accurate. However, Smart
Storm assumes no responsibility for any inaccuracies that may be contained in this manual. In no event will the
Smart Storm be liable for direct, indirect, special, incidental or consequential damages resulting from any defect or
omission in this manual, even if advised of the possibility of such damages. In the interest of continued product
development, Smart Storm reserves the right to make improvements in this manual and the products it describes at
any time, without notice or obligation. Revised editions may be found on the Smart Storm’s web site
www.smartstorm.eu
Safety information
Please read this entire manual before unpacking, setting up or operating this equipment. Pay attention to all danger,
warning and caution statements. Failure to do so could result in serious injury to the operator or damage to the
equipment. Make sure that the protection provided by this equipment is not impaired, do not use or
install this
equipment in any manner other than that specified in this manual.
DANGER
Smart Storm products are designed for outdoor use are provided with a high level of ingress protection
against liquids and dust (see specification for rating). If these products are connected to a mains electricity
socket by means of a cable and plug rather than by fixed wiring, the level of ingress protection of the plug
and socket connection against liquids and dust is considerably lower. It is the responsibility of the operator
to protect the plug and socket connection in such a manner that the connection has an adequate level of
ingress protection against liquids and dust and complies with the local safety regulations.
When the
instrument is used outdoors, it should be connected only to a suitable socket with at
least IP44 rating
(protection against water sprayed from all directions).