8
www.
smartscoop.com
13
www.
smartscoop.com
3
Engage clutch by turning the lever
counterclockwise to the “locked” position
4
Lift the plastic latch cover, and align waste unit vertically above
motor unit, push down lightly until waste unit aligns and latches
engage (you will hear a “CLICK”).
!
Make sure the waste unit
and motor unit are fully
engaged and there is no
gap between them (A).
!
Make sure that latch is
engaged (B).
5
Next, place the straight end of the litter rake into the hole in the waste
unit (A). Then insert the curved end into the rake slot with the end
pointing upward (B).
Note: you will need to hold the rake safety door
open to assemble the litter rake properly. When you release the rake
safety door, it will spring closed.
6
Close the latch cover (A). The rake safety door should always be
closed (B).
POWER
MODE
POWER
MODE
A
B
A
B
POWER MODE
CORRECT
INCORRECT
POWER MODE
A
B
OPEN
CLOSED
RAKE SAFETY DOOR
Care and Cleaning
We do not recommend turning off the SmartScoop
®
Self-Scooping
Litter Box at night.
In order to operate efficiently, the unit must be
able to clean the box after a cat has used it. If the unit is off all night,
extremely large clumps can develop which could keep the unit from
operating properly. Cats are most active at night so SmartScoop needs
to remain powered on to take care of their nighttime trips to the litter box.
Let’s be honest. Self-Scooping litter boxes alleviate the daily chore
of scooping the box, but every litter box needs routine maintenance.
SmartScoop has been designed with ease of cleaning in mind. Its
simple design allows the unit to be disassembled into easily-cleanable
sections.
All of the sensitive electronics are contained in the motor
unit, which must never get wet.
All other parts of the litter box can be
submerged in warm, soapy water for cleaning.
To disassemble for routine cleaning and maintenance:
• Unplug unit from power source.
• Disconnect power cord.
• To clean metal rake, open plastic latch cover (1), open rake safety door
(2) and pull rake up and away from waste unit (3).
• To remove waste unit, flip up latch cover (1), depress black latch (2)
and lift waste unit straight up and away from motor unit (3).
POWER
MODE
POWER
MODE
1
2
3
POWER
MODE
1
2
3
