background image

4

5

.

Switch always on (l)

This mode should be used if you want your water feature to operate during the day with consisten

performance. The battery provides top up power during overcast conditions and will enable the

pump to run on longer into the evening. (See details of performance in various conditions).

Solar runs the pump and supplies some charge to the

battery. Pump performance is maintained when clouds pass

the sun if there is charge in the battery. Pump will only run on

longer if charge has built up in the battery.

Battery will take 2 to

3 days to fully

charge.

Pump will only run when there is sufficient power from the

solar panel. Little or no battery charging occurs so pump

performance is not maintained and does not run on longer.

Battery will take

several days to fully

charge.

No solar power is available, pump will not run and battery will

not charge.

Battery will not

charge.

This mode should be used if you want your battery to charge so that your water feature can be used

regardless of the time of day or weather conditions. The duration of operation will depend on the

weather conditions. Leave your water feature off during the day whilst you are out and switch it on

during the evening when you can enjoy it. Your feature will even work when it is dark provided there

is sufficient charge in the battery. Alternatively leave it off for a number of days to ensure the battery

is fully charged for a special event. The battery has sufficient capacity to run the pump for up to 6

hours without sun (see details below for typical recharge times). Always switch off when not required

to conserve power.

Switch off (O) until required

Battery should full

charge in 1 day.

Solar runs the pump and charges the battery. Pump

performance is maintained when clouds pass the sun. Pump

runs on longer into the evening until battery is flat.

Performance

Weather

ON

OFF

NOTE: Unit is supplied in off (0) position to protect battery, rotate switch to operate

.

This product is designed primarily to operate in summer months but will also work in spring and autumn 
provided there is good sunshine. Performance is directly related to the amount and strength of sunlight received.

Position

IMPORTANT!

When reconnecting the pump and panel take care 
to ensure that the connectors are water tight. Slightly twist the 

connectors when pushing together, ensure the red o-ring 
seal remains in it’s groove and it is not displaced.

Important!

Unplug green battery connector (1) and slide out the

battery pack (2). Replace with new battery and reconnect

Ni-MH 4.8V 1000mAh

1

2

Battery Charging

Battery

Rechargeable battery packs become less efficient with repeated charge and discharge cycles. The capacity of 
the battery may also reduce over time and you may not acheive the 6 hour operation. If you find that the 
battery appears less efficient or does not run as long, we first suggest you try to boost charge it. To do this, 
leave off for 3 to 5 sunny days to allow the maximum charge to the battery. We suggest you do this 
occassionally anyway to help prolong the battery life. If after this boost charge, your battery still does not 
perform to expectations, you should seek a replacement from Customer Service.

Dispose of battery according to local regulations

Position your fountain so that receives direct sunlight. The fountain will NOT work if the solar panel is 
in a shaded area.

Summary of Contents for Smart Solar 42605M01









Reviews: