SMART Embedded Computing Centellis 2x00 User Card-10GE, Installation And Use Manual

Page: 45 / 50

Board Exchange
Centellis 2x00 User Card-10GE Installation and Use (6806800H33E) 45
To install the board into an AdvancedTCA shelf, proceed as follows.
Installation Procedure
The following procedure describes the installation of the board. It assumes that your
system is powered. If your system is not powered, you can disregard the blue LED and thus
skip the respective step. In this case it is a purely mechanical installation.
1. Put on an ESD wrist strap.
2. Connect the strap to the shelf by attaching the front or rear ESD jack /ESD snap.
3. Insert the board into the shelf by placing the left and right edges of the board in the card
guides of the shelf. Ensure that the guiding module of shelf and board are aligned
properly. The alignment pin facilitates the insertion and prevents bent pins.
4. Slide the board into the shelf by using the extraction handles until you feel resistance.
5. Wait until the blue LED is illuminated.
6. Tighten the screws on the left and on the right of the board.
In this way the handle switch activator is closed and the board can be powered. The
blue LED blinks.
7. Wait until the blue LED is switched off.
The switched off blue LED indicates that the board is activated.
8. Attach cables to the front panel connectors as necessary.
4.4 Removing the Board
This section describes how to remove the board from an AdvancedTCA system.
Removal Procedure
The following procedure describes how to remove the board from a system. It assumes that
the system is powered. If the system is not powered, you can disregard the blue LED and
thus skip the respective step. In that case it is a purely mechanical procedure.
1. To extract the active shelf manager initiate a switchover. Otherwise continue with the
next step.
2. Put on an ESD wrist strap.
3. Connect the strap to the shelf by attaching it to the front or rear ESD jack /ESD snap.
The board must only be operated in a shelf that is properly grounded.