Page
15
of
21
©Smart-e(UK) Ltd.
SDS-7000 User Manual
Installation and Operation
Configuration – Serial Control
The SDS presentation switch has the ability to be controlled via 232 using the DSub 9-pin
socket on the rear of the unit.
The pin connections for 232 communications between the SDS and control device are
shown below (pin connections typical for most standard D9 Male – Female Cables).
The Protocol document for the SDS presentation switch can be found on the product page:
www.smart-e.co.uk/product-range/sds-7000
The Smart-e control application can be downloaded from the Smart-e website:
www.smart-e.co.uk/downloads/software
When a successful command has been received and processed via the 232 port the system
will update the lights and LCD on the front of the unit, this can confirm visually if content
cannot be seen from the location of the presentation switch that the command has been
successful.
Serial Protocol Settings
Baud Rate
115200
Data Bits
8
Stop Bits
1
Parity Bits
none
Control Device i.e. PC
D9 Plug
Pin 2 – RX
Pin 3 – TX
Pin 5 - GND
SDS switch/scaler
D9 Socket
Pin 2 – TX
Pin 3 – RX
Pin 5 - GND