SMART Board X800ix, User Manual

Page: 46 / 96

6. Use the handle on the bottom of the lamp module to slide out the lamp and remove it from the
projector.
g
To put the new lamp module into the projector
1. Remove the lamp module from its packaging.
2. Carefully place the new lamp module into the projector using the handle on the top of the
module. When you guide the lamp module into its slot, hold it vertically, and ensure the power
plug makes contact with the power receptacle on the projector by squeezing the power end of
the lamp module gently against the projector.
3. Use the Phillips screwdriver to tighten the captive screws.
4. Carefully slide the lamp cover back onto the projector.
5. Connect the power cable to the wall outlet.
6. Press the
Power button once on the remote control or ECP to confirm that the projector is
operating and that the lamp module is correctly installed.
7. Put the old lamp in a secure container, and handle it gently until you recycle it.
g
To finish the projector lamp installation
1. Once you complete the projector lamp change, turn on the projector.
2. Access the service menu to reset the lamp hour counter (see Resetting the lamp timer on next
page).
3. Activate the projector’s alert e-mails and lamp warnings if they’ve been deactivated (see E-mail
alerts on page 61 and Control panel on page 57).
C H A P T E R 5
Maintaining your interactive whiteboard system
36