SMART Board X800ix, User Manual

Page: 44 / 96

l
When replacing the projector lamp:
o
Turn the projector off and wait 30 minutes for the lamp to cool completely.
o
Do not remove any screws other than those specified in the lamp replacement
instructions.
o
Wear protective eyewear while changing the lamp. Failure to do so can cause injuries
including loss of eyesight if the lamp shatters or bursts.
o
Use only replacement lamps approved by SMART Technologies. Contact your
authorized SMART reseller ( smarttech.com/wheretobuy ) for replacement parts.
o
Never replace the lamp assembly with a previously used lamp assembly.
o
Always handle the fragile lamp assembly with care to prevent premature lamp failure or
exposure to mercury. Use gloves when touching the lamp. Do not touch the lamp with
your fingers.
o
Recycle or dispose of the lamp as hazardous waste in accordance with local
regulations.
You need a Phillips® No. 2 screwdriver and a flat screwdriver to complete these procedures.
g
To remove the old lamp
1. Press the
Power button twice on the remote control or the ECP to turn off the projector.
2. Wait at least 30 minutes for the projector to cool down.
3. Disconnect the power cable from the wall outlet.
C H A P T E R 5
Maintaining your interactive whiteboard system
34