DESCRIPTIONS
OPERATION
INSTRUCTIONS FOR USE
• Efficient energy-saving LED chip
• Simulate the real flame effect,
energy saving and environmental protection
.
• USB charging mode
• Built-in rechargeable Li-ion battery
• Battery usage time up to 10 hours
• Different lampshade for choice
• It must be charged before an initial use.
• During charging, the indicator light is red and it will turn green after fully charged.
• Press ON/OFF button to turn on or turn off the lamp.
• Standby mode is recommended for a long time without use:
Press ON/OFF button for 3 seconds when the lamp is on, the lamp will enter standby mode after a
row of lights at the bottom of the lamp flash 3 times, meanwhile the remote control function will
be invalid if the lamp comes with remote control. Then press ON/OFF button, the lamp will enter
normal mode, and the remote control function will be valid.
• In the condition of low battery, the lamp will be off after a row of lights at the bottom of the lamp
flash 3 times. Please charge the lamp accordingly.
• 99 LED flickering
• USB charging cable
• LED power consumption: 0.2 W
• Recommended operating temperature: -5 to 45°C
• Warranty: 2 year
In the European Union (in accordance with Directive DEEE 2002/96/EC), and also in other
regions, you must return this product to a recycling collection point at the end of its life. As
this product is not ordinary household waste, managing its end of life helps us protect our
environment and limit the use of our natural resources.
We declare that this product complies with the following European directives:
RoHS (2011/65/EU), EMC (2004/108/EC) .
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
SPECIFICATIONS
COMPLIANCE
English
A
USB CABLE
LAMP MODULE
REMOTE CONTROL
(NOT INCLUDED)
LAMPSHADE INSTALLATION:
(FIG.A)
• Install the lamp module into the lampshade
accordingly.
• The lampshade should be aligned with the
magnet located in the lamp.
REMOTE CONTROL OPERATION:
(FIG.B)
• ON: Turn on the lamp
• OFF: Turn off the lamp
NOTE:
Remote control (Not included
）
REPLACING REMOTE CONTROL BATTERY
•
When the unit does not respond to the signal from the remote control,
replace the original battery with a new Lithium battery 3V CR2025.
www.smartandgreen.eu
Diffuser
USB Port
Magnet
Li-lon Battery: 4800mAh
Li-lon Battery: 2400mAh
www.smartandgreen.eu
B
www.smartandgreen.eu
