SMAR DFI302, User Manual, Page: 36 / 218

DFI302 – User’s Manual
3.6
11. Type the IP address, the Sub-Net mask and the default gateway (provided by the network
administrator) to be associated to the DFI302.
ATTENTION
Do not use the IP Address 192.168.164.100 (it is already being used by DFI302). In addition,
be sure that the chosen address is not in use.
HINT
Write down the IP addresses that will be specified and the serial number of each DF51
module. It will help in the identification and diagnostics of possible failures.
12. Click OK to finish this operation.
13. After assigning a new IP address, the process will return to the Dfi Download dialog box.
14. Click Run to fulfill the DFI302 Firmware again.
15. Click Close to exit the Dfi Download dialog box.
Setting up the DFI302 by Software
ATTENTION
The DFI302 can be set up by Syscon, to assure that the procedures in Connecting the
DFI302 in the Sub-Net has been completed successfully.
The DFI302 is fully configured through the Function Blocks available in the Fieldbus Foundation
standard. All the systems (DFI302 and field devices) can be fully set up by only one application.
Process Control, inter-tracking Logic, Prescriptions, Alarms, Calculations and Equations can all be
set up in one environment.