SMAR DFI302, User Manual

Page: 186 / 218

DFI302 – User’s Manual
14.2
Physical Layer and Timeout
In order to visualize the DF51 in the Logic View software it is necessary to configure some
parameters in advance.
Using FBTools, check the IP address of the DF51 to be configured in the Logic View. Thus, every
configuration performed will be sent to DF65, this means that the DF51 will act as bypass.
Remember that the DF65 must have the same baud rate as DF51 (9600 bps default).
In the menu
Tools
of Logic View, select
Comm. Settings
, and then choose
Ethernet
(Modbus/TCP). Type the IP address of the DF51 that the Logic View will establish communication.
See the picture below:
Next, click on the “
Time-out
” tab. Then set the time out and the number the computer should try in
case of a bad communication.
Now the user can create the network ladder configuration and send it to the DF65. See the Logic
View manual for more details.