SMA America, LLC
10 Troubleshooting
Installation Manual
BTRPIN-IA-eng-IUS113911
25
10.2 Connection Signal
The SMA
Bluetooth
Repeater can only display a connection signal if it is integrated in an existing
SMA
Bluetooth
network. The SMA
Bluetooth
network can only be established by master devices* .
Devices will always display the connection signal to the device from which the connection has been
established.
* "Master" is a network engineering term. In a network, a master is a device that requests other devices (slaves) to receive or send
data, for example. All communication products (e.g. Sunny Explorer, Sunny Beam with
Bluetooth
) are masters in an
SMA
Bluetooth
network.
Bluetooth
LEDs
Status
Measure
Blue LED
Yellow LEDs
Connection signal
Very good
None
Permanently on 3 LEDs are
permanently lit
Good
None
2 LEDs on
Unreliable
• Change the position of the
SMA
Bluetooth
Repeater.
or
• Install additional
SMA
Bluetooth
Repeaters.
1 LED is
permanently lit
Critical
3 LEDs off
The SMA
Bluetooth
Repeater
is not connected to the
SMA
Bluetooth
network.
• Check the NetID.
• Change the position of the
SMA Bluetooth Repeater
or install additional
SMA
Bluetooth
Repeaters.
Off
3 LEDs off
There is no device with the
same NetID within the
radio range.
The SMA
Bluetooth
network
has not been established.
The establishment of a
network can only be
triggered by masters, e.g.
communication products.
• Commission a master in
the
SMA
Bluetooth
network.
The "
NetID
" rotary switch is
set to position "
1
" or "
0
".
• Set the "
NetID
" rotary
switch to the NetID of your
plant (see Section 7.2).
3 LEDs flashing
Summary of Contents for BLUETOOTH REPEATER
Page 2: ......
Page 31: ......
Page 32: ...XXX 4 4PMBS DPN 4 4PMBS 5FDIOPMPHZ 4 NFSJDB XXX 4 NFSJDB DPN ...
