6
Insert Soap
Bottle into the Motor
Assembly
B
Place Soap Bottle into Motor Assembly
A
Remove Soap Bottle Cap.
1
Install Spout
A
Slide Rubber Gasket onto
Brass Shank.
B
Guide Brass Shank and
Sensor Cord through hole
in counter.
Align the Motor Assembly with
the mounting holes and secure
with the 3 stainless steel
screws (included).
2
Mount Motor Assembly
B
Using the Motor Assembly as a template, mark the mounting holes on
wall. Make certain that the Motor Assembly is level.
• When mounting onto a concrete wall, drill holes 1/8” diameter and 11/32” or
more in depth for wall anchors.
• When mounting onto a wood panel, drill pilot holes 3/32” diameter in advance.
C
Position Spout to direct
soap into sink.
C
D
Guide Sensor Cord
through Flange Nut. Screw
Flange Nut onto Brass
Shank and tighten.
A
Refer to the illustration below for mounting hole location.
Note:
Completely remove Clip from
Motor Assembly Outlet.
Note:
The Assembly Box must be mounted
vertically as shown.
Screw Tube Connector onto
Spout Shank and tighten.
5
Attach Tube to Faucet Shank
A
Slide Tube Connector
onto Flexible Tube. Insert
Tube Fitting into end of
Flexible Tube.
B
C
Slide Soap Assembly up over Straight Tube and fit into the Motor
Assembly. Twist Soap Assembly clockwise to lock into place.
SENSOR
RUBBER
GASKET
FLANGE
NUT
SENSOR
CORD
BRASS
SHANK
Choose a location where there will be accessibility to the
unit on the underside of the sink (the Motor and Soap
Container cannot interfere with the water or drain lines).
Before drilling holes in the wall, be sure that no other
pipes or wires exist.
!!! IMPORTANT !!!
MOTOR ASSEMBLY OUTLET
4-1/2”
(114 mm)
13/32” (10 mm)
1-7/64” (28 mm)
TUBE FITTING
TUBE
CONNECTOR
SPOUT
SHANK
TUBE
CONNECTOR
SPOUT
SHANK
SOAP BOTTLE
SOAP BOTTLE
ASSEMBLY
PICK-UP
TUBE
MOTOR
ASSEMBLY
CAP
FLEXIBLE TUBE
C/L
O-RING
O-RING
Important:
Make sure
O-rings are in place.
