4
5- REMOVE LABEL FROM SENSOR
Remove label from sensor window.
Adjust lever to set
temperature.
Activate Faucet by holding installation instructions approximately
1-1/2” (38 mm) in front of the sensor window until red light
appears, then remove instruction sheet. Faucet will run for
four (4) seconds and the range will automatically adjust to its
environment. Wait ten (10) seconds after water shuts off before
using faucet.
Activate Faucet and check for leaks. If faucet does not function,
refer to the Troubleshooting section of this instruction manual.
Optional – To fix
temperature, set
lever to the desired
position, then
remove lever and
plug hole with cap
A
A
A
B
B
6 - ACTIVATE FAUCET
7 - SET AND FIX TEMPERATURE
Sensor Label
10 Sec. 10 Sec.
10 Sec.
