Threaded Adapter
Water Supply
Pipe
Iron Pipe Nipple or
Copper Pipe with
Sweat Solder Adapter
Bak-Chek
®
Control Stop
3
1 - INSTALL OPTIONAL SWEAT SOLDER ADAPTER (ONLY IF YOUR SUPPLY PIPE DOES
NOT HAVE A MALE THREAD) AND CONTROL STOP
A
To install the optional sweat solder adapter:
Cut water supply line pipe 1-1/4” (32 mm) shorter. Slide threaded
adapter fully onto pipe and sweat solder to pipe.
B
Install the Sloan Bak-Chek
®
control stop to the water supply line
with the outlet positioned as required.
WITH THE EXCEPTION OF THE CONTROL STOP INLET,
DO NOT USE PIPE SEALANT OR PLUMBING GREASE
ON ANY VALVE COMPONENT OR COUPLING!
!!! IMPORTANT !!!
3 - INSTALL VACUUM BREAKER FLUSH CONNECTION AND BUTTON
2 - INSTALL METAL PUSH BUTTON ACTUATOR
A
Drill a 2” (51 mm) diameter hole through wall, if needed.
B
Screw threaded rod into back of push button actuator.
C
From behind wall, run plastic tubing through space sleeve (notched
end of toward rear) and through wall. Spacer sleeve is only
required if wall thickness is less than 2” (51 mm).
D
Remove tube fitting nuts from push button actuator fittings and
slide one nut onto each plastic tube. Slide each plastic tube onto
its corresponding push button actuator fitting and tighten tube
fitting nuts.
F
From behind wall, slide space sleeve (if required) over threaded rod
and rest it against rear of wall. Slide retaining bar onto threaded
rod and into slots of sleeve. Install lockwasher and nut onto
threaded rod and tighten securely. Carefully cut excess threaded
rod making certain not to damage the plastic tubing.
E
Insert push button actuator assembly into the 2” (51 mm) diameter
hole in wall.
A
Assemble pipe, elbows, couplings, nylon slip gaskets, rubber
gaskets, and flanges, as illustrated.
B
Insert tube into fixture spud.
Vacuum
Breaker
Tube
Outlet
Tube
Spud
Coupling
Nylon Slip
Gasket
Rubber
Gasket
Elbow
Hand tighten all couplings.
C
Nut
Lockwasher
Retaining Bar
Threaded Rod
Quick
Connect
Fittings (2)
Spacer
Sleeve †
Use spacer sleeve only if wall
thickness is less than 2” (51mm)
†
Plastic
Tubing
Metal Push
Button Actuator
Assembly
Wall
Observe the “L” and “O” markings on push button actuator.
Mark each tube so that it can be identified and connected to
corresponding fittings marked “L” and “O” on valve actuator housing.
NOTE
MUST USE SLOAN APPROVED TUBING ONLY
!!! IMPORTANT !!!
