Page 9
CANOPY HOODS - SLIM LINE
IMPORTANT:
Switch off and unplug
the rangehood at the powerpoint before
undertaking any cleaning or maintenance on
the unit.
LED LIGHT REPLACEMENT
220-240 Volts/2 Watts
The entire LED light assembly needs to be
replaced (light board, metal case and lead) as
one piece.
1. Switch off the power to the canopy hood and
remove the filter panles to get access to the
interior of the unit.
2. Follow the LED lamp lead (approximately
30cm) from the back of the light case to find a
white connector. Disconect the lead from the
internal wiring of the range hood.
3. The metal LED light case is kept in place by
two spring levers located at the back of the light
case. Pushing the light case down from the
interior of the unit will allow you to completely
remove the lights.
4. Repeat these steps in reverse to install the
replacement LED light.
GENERAL MAINTENANCE
To prevent any surface damage never use any
abrasive products or products that contain
soda, acids, chlorides or solvents.
To clean the surface of the appliance use a
mild detergent in warm water, with a soft
non-abrasive cloth.
Only use a damp cloth as use of excessive water
can penetrate the unit and cause damage.Dry
surface thoroughly after cleaning with a
soft cloth to prevent marking of the surfaces.
FILTER MAINTENANCE
To ensure that the rangehood performs at it’s
best, filters need to be cleaned cleaned at least
monthly or more frequently with heavy use
The filters can be cleaned using hot soapy
water and a soft nylon brush or placed in a
dishwasher.
NOTE:
Cleaning the filters in the dishwasher
may cause permanent discoloration of the
surface. This does not in any way affect the
performance of the filters.
Charcoal filters cannot be cleaned or reused.
Replace filters every 3-6months dependant on
use and cooking style. Please dispose of used
filters responsibly.
NOTE:
Oversaturated filters are a fire hazard
so regular cleaning/replacement is a must.
MAINTAINING YOUR
RANGEHOOD
