Slendertone System Arms, Instruction Manual

Page: 6 / 20

2
3
4
6
GARMENT SET-UP
1. Connect the controller to the garments. The controller and garments must be
connected properly for your
SLENDERTONE ARMS
to work. “Click” the controller
connector into the garment connector.
2. Place the garments with the four silver studs facing towards you. Remove
the adhesive gel pads from their pack. You will notice that one side of
each gel pad has a
grid pattern on it while the other side is plain black.
3. Remove the covers from the patterned side of the four gel pads. Place
the patterned side of the gel pads over the silver studs and within the
white lines.
4. Remove the covers from the black side of all four gel pads. Do not throw
these away as you will need to put them back onto the gel pads at the end
of your session.
Note:
You should only use
SLENDERTONE
gel pads as other kinds may reduce the
effectiveness of the exercise.
1